Isspro R82077 Manuel d'utilisateur télécharger pdf

PERFORMAX

Form No. IS147 (Rev. A 03/11/2008)

ISSPRO, INC.



2515 N.E. Riverside Way



Post Office Box 11177



Portland, Oregon 97211-1899

503-288-4488



800-888-8065



Fax: 503-249-2999

FUEL PRESSURE GAUGE AND SENSOR INSTALLATION

INSTRUCTIONS

Models: R43044 R43055 R43077 R52044 R52055 R52077 R53044

R53055 R53077 R59044 R59055 R59077 R68044 R68055

R68077 R69044 R69055 R69077 R82044 R82055 R82077

 Disconnect batteries. Do not reconnect battery power until system is

fully configured to avoid risk of shock or fire.

I C O N K E Y

 CAUTION

 Tools may be required

 Shown in picture



Install Electronic Signal Processor (ESP) and ESP harness according to

instructions.

 Connect the Pressure Sensor Harness to the ESP Harness as follows:

a. Remove plugs from cavities 4, 5 and 6 of connector B (black) of the ESP.

b. Using a pair of needle nose pliers, pull the orange wedge lock out of connector B.

c. Insert the terminal from the red wire (5V sensor supply output) into cavity 4 of connector B

on the ESP, pushing until it snaps into connector B.

d. Insert the terminal from the black wire (sensor supply ground) into cavity 5 of connector B on

the ESP, pushing it until it snaps in place.

e. Insert the terminal from the green wire (sensor input) into cavity 6 of connector B on the ESP,

pushing it until it snaps in place.

f. Note: Terminals will be close to flush with the top of the connector when fully seated.

g. A firm pull of the wire will confirm whether they are properly seated.

h. Push the orange wedge lock back into position. If any of the wires are not fully seated, the

wedge lock will not insert into position.

i. Reconnect connector B (black) to the ESP.

Figure 1: Connector B top and bottom

view. Shown with plugs and wedge lock

installed.

Figure 2: Remove plugs and wedge lock as

shown. Wedge lock is replaced once wires are

positioned properly.

1 2

PERFORMAX 1

Résumé du contenu

Page 1 - PERFORMAX

PERFORMAX Form No. IS147 (Rev. A 03/11/2008) ISSPRO, INC.  2515 N.E. Riverside Way  Post Office Box 11177  Portland, Oregon 97211-1899 503-288-

Page 2

Form No. IS147 (Rev. A 03/11/2008) ISSPRO, INC.  2515 N.E. Riverside Way  Post Office Box 11177  Portland, Oregon 97211-1899 503-288-4488  800-

Commentaires sur ces manuels

Pas de commentaire

Isspro R82077 Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Capteurs Isspro R82077. ISSPRO R82077 User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Capteurs Isspro R82077